VHT GSP206 wrinkle plus shrink paint is a blue motorcycle paint and gives a nice effect to all types of engine parts.
The paints in this series are heat resistant up to 177 degrees and resistant to gasoline and other chemicals.

This blue VHT shrink paint is ideal for spraying valve covers, crankcase parts, cylinder heads and parts such as engine brackets, steering racks, etc.

Application of shrink paint blue VHT GSP206 wrinkle plus blue heat resistant
First of all, start by degreasing.

• Parts that still have a good layer of lacquer on them only need to be lightly sanded after degreasing.
• Apply the shrink paint in three layers, from left to right, from top to bottom and diagonally. The first two layers can be quite thick and the last layer slightly thicker.
• After the last layer of shrink varnish, gently heat the varnish with a normal hair dryer.
  After a few minutes the wrinkle effect starts to appear. Continue heating until all the lacquer has swirled.
  
  NOTE: All layers (primer and color) must be applied within approximately one hour. It is recommended to wait 5 – 10 minutes between coats. It is important that you do not let the VHT primer harden first.

Baking off the VHT shrink lacquer
After the last layer, let the part dry for 24 hours and you can start baking, this can be done in the oven: for 1 hour at 90 degrees or by the heat that the engine produces during idling, instructions for this are on the packaging .